| 1. |
- Bengtsson, Magnus, et al.
(författare)
-
Fluorescence lidar imaging of fungal growth on high-voltage outdoor composite insulators
- 2005
-
Ingår i: Optics and Lasers in Engineering. - : Elsevier BV. - 0143-8166 .- 1873-0302. ; 43:6, s. 624-632
-
Tidskriftsartikel (refereegranskat)abstract
- Remote fluorescence imaging of fungal growth on polymeric high-voltage insulators was performed using a mobile lidar system with a laser wavelength of 355 nm. Insulator areas contaminated by fungal growth could be distinguished from clean surfaces and readily be imaged. The experiments were supported by detailed spectral studies performed in laboratory using a fibre-optic fluorosensor incorporating an optical multi-channel analyser system (OMA) and a nitrogen laser emitting radiation at 33 7 nm.
|
|
| 2. |
- Lavrencik, Justin, et al.
(författare)
-
Error-Free 100Gbps PAM-4 Transmission over 100m Wideband Fiber using 850nm VCSELs
- 2017
-
Ingår i: European Conference on Optical Communication, ECOC. ; 2017-September, s. 1-3
-
Konferensbidrag (refereegranskat)abstract
- We experimentally demonstrate error-free rates beyond 100Gbps over 100m WBMMF. Power penalties and maximum data rates of PAM-2 and PAM-4 using shaped and unshaped pulses were studied. The link includes unpackaged 850nm VCSELs with different apertures and only transmitter equalization.
|
|
| 3. |
- Appelgren, Patrik, et al.
(författare)
-
Modeling of a small helical magnetic flux compression generator
- 2008
-
Ingår i: IEEE Transactions on Plasma Science. - 0093-3813 .- 1939-9375. ; 36:5, s. 2662-2672
-
Tidskriftsartikel (refereegranskat)abstract
- In order to gain experience in explosive pulsed power and to provide experimental data as the basis for computer modeling, a small high-explosive-driven helical magnetic flux-compression generator (FCG) was designed at the Swedish Defence Research Agency. The generator, of which three have been built, has an overall length of 300 mm and a diameter of 70 mm. It could serve as the energy source in a pulse-forming network to generate high-power pulses for various loads. This paper presents a simulation model of this helical FCG. The model, which was implemented in Matlab-Simulink, uses analytical expressions for the generator inductance. The model of resistive losses takes into account the heating of the conductors and the diffusion of the magnetic field into the conductors. The simulation results are compared with experimental data from two experiments with identical generators but with different seed currents, influencing the resistive losses. The model is used to analyze the performance of the generator.
|
|
| 4. |
- Appelgren, Patrik, et al.
(författare)
-
Small Helical Magnetic Flux-Compression Generators : Experiments and Analysis
- 2008
-
Ingår i: IEEE Transactions on Plasma Science. - 0093-3813 .- 1939-9375. ; 36:5, s. 2673-2683
-
Tidskriftsartikel (refereegranskat)abstract
- In order to gain experience in explosive pulsed power and to provide experimental data for modeling, a small high-explosive-driven helical magnetic flux-compression generator (FCG) was designed at the Swedish Defence Research Agency (FOI). The generator, of which three have been built, has an overall length of 300 mm and a diameter of 70 mm. It could serve as the energy source in a pulse-forming network to generate high power pulses for various loads. This paper presents the design of, and tests with, this helical FCG. The generator had an initial inductance of 23 mu H and was operated into a load of 0.2 mu H. The generator is charged with 0.27 kg of high explosives (PBXN-5). Various types of diagnostics were used to monitor the operation of the generator, including current probes, optical fibers, and piezo gauges. With seed currents of 5.7 and 11.2 kA, final currents of 269 and 436 kA were obtained, corresponding to current amplification factors of 47 and 39. The peak of the current was reached about 30 mu s after the time of crowbar. The two generators showed only small losses in terms of 2 pi-clocking. Using signals from optical fibers, the deflection angle of the armature could be determined to be 10 degrees in good agreement with hydrodynamic simulations of the detonation process and the detonation velocity to be 8.7 km/s in agreement with tabulated value.
|
|
| 5. |
- Karlsson, Mikael, 1978, et al.
(författare)
-
Characterization of paint formulated using secondary TiO2 pigments recovered from waste paint
- 2019
-
Ingår i: JCT Research. - : Springer Science and Business Media LLC. - 1547-0091 .- 2168-8028 .- 1935-3804. ; 16:2, s. 607-614
-
Tidskriftsartikel (refereegranskat)abstract
- The paint industry is continuously striving to reduce its environmental impact, especially when it comes to the major virgin white pigment, titanium dioxide (TiO2). In this work, recycled TiO2 pigment was used in a paint formulation as a replacement for pigment made from virgin raw materials. The paint was evaluated based on pH, Stormer and ICI viscosities, gloss, hiding power, and color characteristics. The paint films were also characterized by LVSEM–EDS, AFM, and profilometry. The most significant difference between a paint based on recycled pigments and a paint based on virgin pigments was the agglomeration of pigment particles which gave a reduction in gloss and a rougher surface of the dried paint film based on recycled pigment, and it could be concluded that the recycled pigment could not be used without accepting a small decrease in paint quality. This points toward two main directions: (1) the use of recycled pigment in applications with less demand on surface finish and gloss, such as ceiling paints, and (2) that further work on formulation should be carried out with the recycled pigment as for any other new pigment introduced in a paint formulation to optimize its performance. © 2018, The Author(s).
|
|
| 6. |
- Grabowski, Alexander, 1993, et al.
(författare)
-
Impact of Carrier Transport and Capture on VCSEL Dynamics
- 2023
-
Ingår i: IEEE Journal of Quantum Electronics. - 0018-9197 .- 1558-1713. ; 59:1, s. 1-6
-
Tidskriftsartikel (refereegranskat)abstract
- Using a vertical-cavity surface-emitting laser (VCSEL) equivalent circuit model based on two carrier rate equations to include effects of carrier dynamics, we study the impact of carrier transport and capture on the small- and large-signal modulation response of high-speed VCSELs. The model also accounts for parasitics, current-induced self-heating, and gain compression. A variation of the effective capture time from 1 to 15 ps is found to have a large impact on the small-signal modulation response, with the 3 dB bandwidth decreasing from 40 to 15 GHz and the response transitioning from under-damped to over-damped. This is primarily due to the increasing low frequency parasitic-like roll-off with increasing effective capture time. A significant effect on the optical waveforms produced by the VCSEL under 56 Gbit/s on-off keying (OOK) non-return-to-zero (NRZ) and pulse-amplitude modulation 4 (PAM4) modulation is observed, with a short effective capture time leading to horizontal eye closure caused by timing jitter (TJ) and intersymbol interference (ISI) and a long effective capture time leading to vertical eye closure caused by long rise- and fall-times. However, for high modulation speed, a short effective capture time is needed and the photon lifetime should be set for clear eye opening. We also show the impact of the effective capture time on the output power vs current characteristics and map the dependence of internal temperature, carrier densities, carrier escape and leakage rates, and spontaneous recombination rates on current for different effective capture times.
|
|
| 7. |
- Srinivasan, Muralikrishnan, 1991, et al.
(författare)
-
End-to-End Learning for VCSEL-based Optical Interconnects: State-of-the-Art, Challenges, and Opportunities
- 2023
-
Ingår i: Journal of Lightwave Technology. - 0733-8724 .- 1558-2213. ; 41:11, s. 3261-3277
-
Tidskriftsartikel (refereegranskat)abstract
- Optical interconnects (OIs) based on vertical-cavity surface-emitting lasers (VCSELs) are the main workhorse within data centers, supercomputers, and even vehicles, providing low-cost, high-rate connectivity. VCSELs must operate under extremely harsh and time-varying conditions, thus requiring adaptive and flexible designs of the communication chain. Such designs can be built based on mathematical models (model-based design) or learned from data (machine learning (ML) based design). Various ML techniques have recently come to the forefront, replacing individual components in the transmitters and receivers with deep neural networks. Beyond such component-wise learning, end-to-end (E2E) autoencoder approaches can reach the ultimate performance through co-optimizing entire parameterized transmitters and receivers. This tutorial paper aims to provide an overview of ML for VCSEL-based OIs, with a focus on E2E approaches, dealing specifically with the unique challenges facing VCSELs, such as the wide temperature variations and complex models.
|
|
| 8. |
|
|
| 9. |
- Franke, Axel, et al.
(författare)
-
The effect of in-cylinder gas flow on the interpretation of the ionization sensor signal
- 2003
-
Ingår i: SAE Technical Papers. - Warrendale : S A E Inc..
-
Konferensbidrag (refereegranskat)abstract
- The location of the peak pressure can serve as a control parameter to adjust ignition timing and optimize engine performance. The ionization sensor, an electrical probe for combustion diagnostics, can provide information about the peak pressure location. However, the reliability of such information is rather poor. In-cylinder gas flow at the electrodes may be one reason for this. We present results from an investigation of the relationship between ionization sensor current and pressure under various gas flow conditions. The gas flow velocity in the vicinity of the electrode gap was measured by LDA. From the results one may infer how the in-cylinder gas flow affects the reliability of the prediction of pressure peak location from the ionization sensor signal. One finding is that high bulk gas flow impairs the precision of the prediction in certain configurations.
|
|
| 10. |
|
|
